Wax & Cleaner
Support DocumentsPDS GHS SDS
COMBUSTIBLE MIXTURE, N.Y.F.D.C. OF A. NO.1187
Contains petroleum distillates and diacetone alcohol. Harmful or fatal if swallowed. Do not take internally. Avoid contact with skin and eyes. Wear rubber gloves and safety glasses when handling. Avoid inhalation and use only with adequate ventilation. If adequate ventilation cannot be maintained, wear respiratory protection (NIOSH/MSHA TC23C or equivalent) or leave the area. Do not use or store near heat, sparks, flame or other sources of ignition. Close container after each use.
If swallowed, do not induce vomiting. Call physician immediately. For skin contact, was thoroughly with soap and water. If irritation persists, get medical attention. In case of eye contact immediately flush eyes thoroughly with water, then remove any contact lenses. Continue to flush eyes with water for at least 15 minutes. If irritation persists, get medical attention. If affected by inhalation, immediately remove to fresh air. If symptoms persist, contact a physician.
A blend of cleaning agents and wax designed to remove scuff marks and built up dirt while adding a soft sheen to waxed hardwood floors. Available in Neutral for light surfaces and Coffee Brown for dark surfaces.
On waxed hardwood floors.
Remove dust and grit by sweeping or vacuuming
- Shake container well before use.
- Using a cloth or a fine steel wool pad, spread Wax & Cleaner over the woodfs surface at a coverage rate of 500 square feet per gallon.
Gently rub the surface to loosen dirt. Wipe away loosened dirt and allow to dry 20-30 minutes.
NOTE: Drying time will be increased by high humidity, low temperature or applying too heavily.
- Polish with a clean cloth or polishing machine.
Do not use on surfaces other than wood.
Do not use polyurethane over Wax & Cleaner.
Do not thin or adulterate.
|Type||Size||Prod. No.||Qty||PDS||GHS SDS||CPIC|
|COVERAGE||Approximately 500 square feet per gallon.|
|MAINTENANCE||As necessary, remove dust and grit by sweeping or vacuuming. Wipe up spills as soon as possible. Periodic buffing will renew luster. Exceptionally worn areas may occasionally require an additional coat of Wax & Cleaner.|
|STORAGE||Keep containers tightly closed. Isolate from heat, electrical equipment, sparks, and open flame.|
|Density (lbs/gal)||6.9 (Typical)|
|% Solids||20.6 (Typical)|
|Flash Point||Greater than 101°F - Seta Flash|