| DURA
SEAL Pastels Stain
PRODUCT MSDS
Pastels Stain - Material Safety Data Sheet
PRODUCT
DESCRIPTION:
This line of penetrating, oil-based stains imparts rich pastel
colors to the wood that complement today's designer look. Available
in Country White, Golden Wheat and Stone Grey, DURA SEAL
Pastels Stain highlights rather than hides the natural grain of
the wood.
DIRECTIONS:
Surface Preparation:
1. Properly prepare surface according to NOFMA or NWFA approved
methods.
2. Final Sanding should be done with eighty (80) grit screen to
allow deeper penetration of stain.
3. Remove all dust with a broom and/or vacuum and tack surface
with a clean towel moistened with mineral spirits.
Application:
1. Stir material thoroughly before and occasionally during use.
Apply a test sample on a small inconspicuous area before proceeding
with entire job to insure desired color. Always stain with the
grain.
2. Apply the first coat of DURA SEAL
Pastels Stain with a brush, lambs wool applicator or cloth. NOTE:
Do not use steel wool. To ensure adequate open time and to maintain
a wet edge, apply liberally at an application rate of approximately
400 square feet per gallon.
3. Allow to penetrate for 2 to 4 minutes then remove excess by
wiping with clean rags.
NOTE: Do not use steel wool. DURA SEAL
Pastels Stain dries faster than DURA SEAL
Penetrating Finish, 200 Series. If stain becomes tacky, wipe
surface with a rag moistened with mineral spirits. Removal of
all excess material is essential to ensure proper dry time.
4. A second coat may be applied if greater color density is desired.
Allow first coat to dry approximately 8 hours before applying
a second coat of non-yellowing top coat. Allow stain to dry 3
days before applying a non-yellowing water borne top coat.
PRECAUTION:
Do not use steel wool. To avoid discoloration, use of a non-yellowing
top coat over DURA SEAL Pastels is
recommended.
IMPORTANT:
Immediately after use, place rags, steel wool and other waste
in a sealed, water filled metal container. See cautionary statement.
PRODUCT PROPERTIES:
| COATS REQUIRED |
Apply only one (1) coat |
| DRY TIME |
Approximately 8 hours to overnight.
Allow stain to dry 3 days before applying a non-yellowing
water borne top coat.
NOTE: Drying time will be increased by high humidity, low
temperature, lack of air movement or incomplete removal of
excess stain. |
| COVERAGE |
Approximately 400 square feet
per gallon. |
| CLEAN UP |
Clean equipment
with mineral spirits. |
| STORAGE |
Approximately 400
square feet per gallon. |
| SOLVENT |
Non-photochemically
reactive. |
CAUTION:
COMBUSTIBLE MIXTURE N.Y.F.D. C. OF A. NO.1187
KEEP OUT OF REACH OF CHILDREN.
DANGER:
Contains mineral spirits. Harmful or fatal if swallowed. Do not
take internally. Skin irritant. Avoid contact with skin and eyes.
Wear rubber gloves and safety glasses when handling. Avoid inhalation
and use only with adequate ventilation. If adequate ventilation
cannot be maintained, wear respiratory protection [NIOSH/MSHA
TC23C or equivalent] or leave the area. Do not use or store near
heat, sparks, flame or other sources of ignition. Close container
after each use. Rags, steel wool or waste soaked with DURA SEAL
Pastels Stain may spontaneously catch fire if improperly discarded.
Immediately after use, place rags, steel wool, and other waste
in a sealed, water filled metal container. Dispose of in accordance
with local fire regulations.
FIRST AID:
If swallowed, do NOT induce vomiting. CALL PHYSICIAN IMMEDIATELY.
For skin contact, wash thoroughly with soap and water. If irritation
persists, get medical attention. If affected by inhalation, remove
to fresh air and CALL PHYSICIAN. In case of eye contact, immediately
flush eyes thoroughly with water, then remove any contact lenses.
Continue to flush eyes with water for at least 15 minutes. If
irritation persists, get medical attention.
| Color |
Size |
SKU # |
Case/Pack |
| COUNTRY WHITE |
QT |
60400 |
6 |
| COUNTRY WHITE |
Gal |
10400 |
4 |
| STONE GRAY |
Gal |
10401 |
4 |
| GOLDEN WHEAT |
Gal |
10402 |
4 |
4/30/99
lit # 05990013
|